Media Handling
This option specifies how the printer will handle the media (paper or tag stock).
•Continuous. Printer prints on the media and sends it out the front or rewinds the printed media onto the internal rewinder. The label taken sensor gate should be in the up (disabled) position to support continuous.
•Tear-Off Strip. Prints until the print buffer is empty, then positions the last label over the tear-off bar for removal. The label taken sensor gate should be in the up (disabled) position to support tear-off strip.
•Tear-Off.After each label is printed, the printer positions the label over the tear off bar and waits for you to tear off the label before printing the next one (on-demand printing). A LABEL PRESENT/Remove Label message will display to remind you to remove the label before the next one can be printed. The label taken sensor gate must be in the down (enabled) position to support tear-off.
•Peel-Off.Prints and peels die-cut labels from the liner without assistance. The printer waits for you to take away the label before printing the next one (on-demand printing). The label backing is rewound on the internal rewinder. A LABEL PRESENT/Remove Label message will display to remind you to remove the label before the next one can be printed. The label taken sensor gate must be in the down (enabled) position to support peel-off.
•Cut. When the optional media cutter is installed, it automatically cuts media after each label is printed or can cut after a specified number of labels have been printed using a software cut command. It cuts continuous roll paper, labels, or tag stock. The label taken sensor gate must be in the up (disabled) position to support cut.
Paper Feed Shift
This option represents the distance to advance a label when the Tear-Off Strip, Tear-Off, Peel-Off, or Cut media handling option is enabled.
Hor Image Shift
This option specifies the amount to shift an image horizontally left (-) or right
(+)for precise positioning on the page. The actual width of the image is not affected by this parameter. The allowable range is -1.00 through +1.00 inches in .01 inch increments, displayed as xx/100. The factory default value in inches is 0.
Ver Image Shift
This option specifies the amount to shift an image vertically up (-) or down (+) for precise positioning on the page. The actual height of the image is not affected by this parameter. The allowable range is -1.00 through +6.00 inches in .01 inch increments, displayed as xx/100. The factory default value in inches is 0.