Modifying A Saved Configuration
Modifying A Saved Configuration
You can change a saved configuration by rewriting over it. For example, you can modify Config. 1, shown below. Suppose you want to keep all the settings but you want to select the parallel interface instead of the serial interface.
Config. 1: Selects
Selects Image Horizontal Shift of 0.20 inches, etc.
1.Load the configuration to be changed (for example, Config. 1).
a.Press the PAUSE key to take the printer offline.
OFFLINE
CONFIG. CONTROL
b.Press the6 key.
CONFIG. CONTROL Load Config.
c.Press the6 key.
Load Config. 1*
d.Press the3 or 4 key to cycle through the options: Factory
e.When the desired number displays, press the ENTER key to select it. The following message is displayed while loading.
Loading Saved Configuration
Then, the following message displays when it is loaded:
Load Config.
X*
2.Move through the menu and change all the desired values. (In this example, under Host Interface, you would change the value from Serial to Centronics.)
3.Press the ENTER key to save each new value. An asterisk (*) displays.
4.Before saving the modified configuration, you must delete the original configuration if the Protect Configs. option is enabled.
a. Press the 5 key.
59
