Printronix T4204 manual Appendix a

Appendix A

Media:
Type:	Roll-fed, die-cut continuous or fan-fold labels,
	tags or tickets; most direct thermal or thermal
	transfer materials.
Supply Roll:	8 in. (203 mm) maximum diameter on 3” (76
	mm) diameter cores.
	7 in. (178 mm) maximum diameter on 1" (25
	mm) diameter cores.
Internal Rewinder:	Accepts a 5 inch diameter roll of labels or label
	backing.
Label Material:	Thermal transfer plain-coated papers, vinyl,
	Mylar®, metallized paper, non-woven fabric, fine
	woven fabric, thermal-visible light scannable
	paper, infrared scannable paper, thermal ticket/
	tag stock, thermally sensitive plastic stock.
Thermal Transfer	Standard Widths are:
Ribbons:	1.00” (25mm)
	1.57” (40mm)
	2.36” (60mm)
	3.15” (80mm)
	4.33” (110mm)
Media Sensing:	Moveable “see-through” for die-cut labels and
	reflective for tags with black striping.
	The T4204 printer uses a movable sensor to
	detect index holes/notches or the black stripe in
	tag stock. The Transmissive sensor position is
	indicated by the sensor crystal at the front of the
	label guide that is visible with the printhead
	open. The Reflective sensor position is located
	under the R2, far right side resistor, also visible
	with the printhead open. The sensor can be
	moved by squeezing the two locking tabs,
	located under the label guide, and sliding the
	sensor assembly in or out. For proper sensing,
	ensure that the sensor is aligned with the center
	portion of the index hole/notch or black stripe.
Label Taken Sensor:	Detects when a printed label is at the printer exit
	throat.
Automatic Label	Peels and presents label to the operator, one at
Peel-Off:	a time.

202