Section 6 COPY DEFAULT SETTINGS
20 Prior to performing the adjustment procedure, it is necessary to use the Document Processor to make copies in a standard copy mode in order to check the amount of skewed feed that is produced.
This procedure assumes that you are using the pattern that is printed out using the “F27” default item (Upper Drawer Skewed Feed Adjustment) as an original.
(F30)
21 Select a standard copy mode and set the original in the Document Processor. Set the original into the Document Processor in the direction shown in the illustration and make a copy.
22 Refer to steps 1 and 2 and access the actual “F30” default item.
23 Press the Recall%/Enter key.
24 Fold the printed sheet (that you made in step 21) up the middle and compare the true center with the printed center line.
25 If the result is as shown in example (1), increase the setting. If the result is as shown in example (2), decrease the setting.
+
(1)
–
(2)
NOTE
For each tenth (0.1) that you increase the setting, the image will be moved 0.1 mm to the right.
26 Press the Recall%/Enter key. The operation panel will return to the display in step 2.
27 Press the Reset/Power key. The copier will return to a
(printed center line)
NOTE
Use the Document Processor to make another copy and, if further adjustment is necessary, repeat steps 22 through 27.
