Section 7 OPTIONAL EQUIPMENT

Setting originals on the platen

When copying from an original which cannot be set in the Document Processor (books, magazines, etc.), lift open the Document Processor and set the original directly on the platen.

1 Lift open the Document Processor.

IMPORTANT!

Before opening the Document Processor, make sure that there are no originals remaining on the original table or the original eject table. If there are any originals left on either table, they may fall off the copier when the Document Processor is opened.

2 Set the original to be copied face-down. Be sure to align the original flush up against the left rear corner of the platen.

3 Close the Document Processor.

IMPORTANT!

DO NOT put undue pressure on the Document Processor when you close it. Doing so might break the platen glass.

NOTE

Shadows may appear around the edges and up the middle of copies made from open-faced originals (such as books, etc.).

CAUTION

DO NOT leave the Document Processor open as there is a danger of personal injury.

7-3

Page 65
Image 65
Kyocera copier manual Setting originals on the platen