Section 8 TROUBLESHOOTING

Indication

Procedure

Reference

Page

 

 

 

 

 

 

 

 

“E72” appears on the copy quantity/

Originals for another job were set in the optional Document Processor

magnification display

during copying from the platen in the 2-in-1 or 4-in-1 layout mode or in

 

 

the Sort mode.

 

 

Remove the new originals from the Document Processor and, once the

 

 

copy operation for the 2-in-1 or 4-in-1 layout mode or the Sort mode is

 

 

completed, reset them on the original table and try to copy again.

 

 

 

 

“E90” appears on the copy quantity/

The copier’s memory is full.

magnification display

To copy from those originals already scanned:

 

 

Press the Recall%/Enter key and copying will begin. Once those copies

 

 

have been made, reset the originals that have not yet been copied and

 

 

press the Start key. Copying will continue.

 

 

To start the copy procedure once again from the beginning:

 

 

Press the Stop/Clear key, set a lesser number of originals and try to copy

 

 

again.

 

 

 

 

“OP” appears on the copy quantity/

The upper front cover or the front cover to the copier is open.

magnification display

Close the covers securely.

 

 

 

 

“OP1” appears on the copy quantity/

The left cover to the Document Processor is open.

magnification display

Close the cover securely.

 

 

 

 

“J” and a number appear on the copy

A paper jam has occurred.

8-3

quantity/magnification display

Refer to “If paper jams” on page 8-3and remove the jammed paper.

 

 

 

 

The Add Toner indicator lights

The toner supply has run low.

9-2

 

Copying will still be available for awhile, but will then become impossible.

 

 

Replace the toner container as soon as possible.

 

 

 

 

The Add Toner indicator lights and “E33”

Toner has run out so further copying is impossible.

9-2

appears on the copy quantity/magnification

Replace the toner container.

 

display

 

 

 

 

 

“C” and a number appear on the copy

Turn the power switch OFF ({) and then back ON ( ) again. If the error

quantity/magnification display

indication does not go out, make a note of the “C” and the number. Turn

 

 

the power switch OFF ({), remove the power cord, and contact your

 

 

service representative or an authorized service center.

 

 

 

 

“A” and a number appear on the copy

Turn the power switch OFF ({) and then back ON ( ) again. If the error

quantity/magnification display

indication does not go out, make a note of the “A” and the number. Turn

 

 

the power switch OFF ({), remove the power cord, and contact your

 

 

service representative or an authorized service center.

 

 

 

 

8-2

Page 68
Image 68
Kyocera copier manual Troubleshooting