Kyocera 3750 FCC statement, Conforming to the Class a limits, Conforming to the Class B limits

Introduction

12.YOU ACKNOWLEDGE THAT YOU HAVE READ THIS AGREEMENT, UNDERSTAND IT, AND AGREE TO BE BOUND BY ITS TERMS AND CONDITIONS. NEITHER PARTY SHALL BE BOUND BY ANY STATEMENT OR REPRESENTATION NOT CONTAINED IN THIS AGREEMENT. NO CHANGE IN THIS AGREEMENT IS EFFECTIVE UNLESS WRITTEN AND SIGNED BY PROPERLY AUTHORIZED REPRESENTATIVES OF EACH PARTY. BY OPENING THIS DISKETTE PACKAGE, YOU AGREE TO ACCEPT THE TERMS AND CONDI- TIONS OF THIS AGREEMENT.

FCC statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter- ference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

❒Reorient or relocate the receiving antenna.

❒Increase the separation between the equipment and receiver.

❒Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

❒Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the manufacturer for compliance could void the user's authority to operate the equipment.

Shielded circular cable should be used for interfacing with the computer.

Caution to user

Any modification without prior permission may cause harmful interference.

If any modification/change is introduced to this equipment without prior permission, Kyocera as the manu- facturer cannot guarantee compliance with FCC rules.

To use equipment which does not comply with FCC rules is prohibited.

The printer may be optionally installed with the following units:

Conforming to the Class A limits

❒HS-3E Bulk Paper Stacker (for FS-3750)

❒PF-7E Bulk Paper Feeder

Conforming to the Class B limits

❒EF-1 Envelope Feeder

❒DU-20 Duplexer (for FS-3750)

❒DU-21 Duplexer (for FS-1750/FS-3750)

❒HS-20 Paper Handler/Stacker (for FS-3750)

❒HS-21 Paper Handler/Stacker (for FS-1750/FS-3750)

❒PF-20/PF-20mini Paper Feeder (for FS-3750)

❒PF-21/PF-21mini Paper Feeder (for FS-1750/FS-3750)

❒SO-6 Sorter/Stacker

❒ST-20 Bulk Paper Stacker

iv