5.5 Indicators and Messages

Message

Corrective Action

 

 

0(025<&$5' HUUúú

This message appears when an error occurs during access to the memory card using

3UHVV &217,18(

the PRESCRIBE 2e RWER (ICCD) command or from the printer's control panel. Look

 

at the error code given in place ofýúú and refer to the corresponding description given

 

below. Note that error codes ofýíä and above only result when memory card opera-

 

tions are done fromthe control panel.

 

íì:Data or memory card capacity is too large.

 

• This error code appears if an attempt is made to write more than 32 MB of data

 

to a memory card or if the capacity of the memory card installed in the printer

 

is more than 32 MB. Decrease the data being written to the memory card to less

 

than 32 MB. Note that only the memory card of 32 MB and less can be used by

 

this printer.

 

• This error code appears when a data name not existing on the memory card is

 

specified.

 

Check the data names on the memory card.

 

íë:The memory card does not meet specifications. This memory card cannot be used

 

by this printer. Insert a memory card which can be used by this printer.

 

(See "Memory Card" of Chapter 2.)

 

íê:The memory card is not a JEIDA card. Only a JEIDA Ver. 4.2 memory card can

 

be used by this printer.

 

íé:The card is an S-RAM or flash card which cannot be used by this printer.

 

íè:There is no battery in the memory card. Replace the battery in the memory card

 

with a new one.

 

íç:The memory card is write-protected. Cancel the write-protection of the memory

 

card.

 

íæ:The memory card requires formatting. Format the memory card from the control

 

panel.

 

íä:The capacity of the memory card is insufficient. This error code appears when an

 

attempt is made to write more data on the memory card than available memory.

 

To halt the writing of data, first stop data transmissions from the computer, and

 

then the printer's CONTINUE key. Press the FORM FEED key if the messageý

 

:DLWLQJ will appear in the message display. The message display will return

 

to readingý5HDG\.

 

ìì:The memory card is full of data items. The number of data items which can be

 

written on the memory card is limited to 127. Pressing the CONTINUE key will

 

restore the messageý5HDG\ in the message display.

 

ìê:This is a logical error. Try substituting another flash memory card.

 

ìæ:The flash memory card cannot be written due to insufficient printer memory.

 

Either delete unnecessary macros and/or fonts stored in the printer, or expand

 

the printer's available memory.

 

ìå:This is a write error. Try substituting another flash memory card. (Error codes

 

ìê throughýìå apply only to a flash memory card.)

 

 

,î) RFFXSLHG

This message is displayed when you attempt to use the printer's control panel to

 

change the environmental settings on the interface from which data are presently

 

being received.

 

 

3URFHVVLQJ

),7 (image FITting) flashes to indicate that a loss of raster data occurred when the

3$5 ),7 $é

data was compressed to be fitted within the currently available memory. Flashingý

 

),7 extinguishes automatically when the job times out; the printer receives the next

 

data from the host computer; or if you press any key on the printer's control panel. Try

 

adding more memory in the printer to prevent this error.

 

 

5-11