Kyocera FS1750, 3750 manual On-line/Off-line Setting, Canceling Printing

2.2. Operating Procedures

On-line/Off-line Setting

By pressing the ON LINE key you can change the printer between the on-line state, in which it prints the data it receives from the computer, and the off-line state, in which it stores the data for printing later.

1.Make sure that the message display indicatesý5HDG\.

2.Press the ON LINE key.

If the printer is on-line, it changes to off-line. If the printer is off-line, it changes back to on-line.

The ON LINE indicator lights when the printer is on-line.

Going off-line may or may not halt communication between the printer and computer, depending on details of the current interface. While off-line, the printer continues to accept any data that arrives until the current interface buffer is full, at which point it instructs the computer to stop sending data. Data stored while off- line are printed when the printer is returned to the on-line state.

Canceling Printing

Perform the following procedure when you wish to cancel printing after it has begun.

1.Check if the messageý3URFHVVLQJ is displayed in the message display.

2.Press the ON LINE key to take the printer offline.

3.Perform the necessary procedure on the computer to halt printing.

4.Press the CANCEL key.

5.The messageý3ULQWý&DQFHO" will appear in the message display and the interface to be canceled will be displayed.

3DUDOOHO

6HULDO

2SWLRQý (appears only when an optional interface is installed)

6.Selecting the interface to cancel using the + or – key and then press the ENTER key. Printing from the interface selected will be stopped.

A few pages may be printed even after the CANCEL key is pressed as remaining data received before the CANCEL key was pressed is printed.

The messageý3ULQWý&DQFHO"ý&XUUHQWýMRE will also be displayed when the CANCEL key is pressed for the purpose of stopping the printing of status pages or font lists from the control panel. When the ENTER key is pressed, the messageý&DQFHOOLQJýGDWD appears in the message display and printing stops after the printer finishes printing the current page.

Press the CANCEL key again if you wish to stop the cancellation of printing.

Press the ON LINE key to put the printer back online to continue with other print jobs.

☛Canceling data from the computer using the CANCEL key will restore temporary settings to their default values. (The same status resulting from executing the PRESCRIBE 2e RES command.)

☛It is impossible to cancel printing of just one side when printing in duplex mode using an optional duplexer (DU-21).

2-7