4.2.Cleaning
4.2.Cleaning
In addition to the maintenance procedures described on the following pages, the charger wire in the drum unit and paper feed unit should be cleaned from time to time, or whenever print quality problems occur.
To avoid print quality problems, the following printer parts must be cleaned with every toner container replacement.
☛If the toner container has been replaced when the messageý5HSODFH 7RQHUý
&OHDQ SULQWHU was displayed, the messageý&OHDQ SULQWHU 3UHVVý&217,18(will be displayed after replacement. After cleaning the inside of the printer following the procedure shown below, press the CONTINUE key; the message will disappear and the printer will be ready for printing.
Main Charger Unit
The main charger unit grid should be cleaned when the toner container is changed.
Cleaning the Charger Wire
1. Open the printer side cover. | Main Charger Unit |
Side Cover
2. Pull the cleaning knob (Green) slowly in and out a |
|
few times. This pulls a cleaning pad inside the drum | Cleaning Knob |
unit along the wire. | (Green) |