Lanier LD060 manual Copying Book Originals, Repeat, Base point, Vertical length, Horizontal length

Supplementary Specifications

•If the number of originals placed is less than the number specified for com- bining, the last page is left blank, as shown in the illustration.

❖Copying Book Originals

•The machine sets the reproduction ratio automatically to meet paper size and copies originals together onto the paper.

•The machine uses ratios in the range of 25 to 400%

•If the calculated ratio is under the available minimum, it will be adjusted to minimum ratio. However, with some ratios, parts of the image might not be copied.

•Even if the direction of originals is different from that of the copy paper, the machine will automatically rotate the image by 90°to make copies properly.

•If you mix originals of different sizes or place originals in different orien- tations, you cannot use this function.

•Four originals are copied onto each sheet of copy paper with this function. If the number of originals scanned is less than a multiple of 4, the last page will be blank.

•Copying to make a magazine may take some time after scanning originals.

•If the Booklet Finisher is installed and you select "Magazine" and "Staple (Saddle Stitch)", copies are stacked, stapled at the center, folded in half au- tomatically, and then delivered.

❖Repeat

Depending on paper size, ratio, and orientation, parts of repeated images may not be copied.

•If you use this function with "Custom Size Original", you can copy repeat- edly the image in the area you want by specifying the vertical and horizon-

tal lengths from the base point. In this case, place your original on the exposure glass. ⇒ p.16 “Placing Custom Size Originals”

1. Base point 3. Vertical length

2.Horizontal length

6

121