Lanier LD075, LD060 manual Troubleshooting, Problem, Cause, Action

4

Troubleshooting

Problem	Cause	Action
In Image Repeat mode, the	You selected copy paper	Select copy paper larger than the
original image is not cop-	the same size as the origi-	originals.
ied repeatedly.	nals, or you did not select
		Select the proper reproduction ratio.
	the proper reproduction
	ratio.
The stamp position is	The paper orientation is	Check the paper orientation and
wrong.	wrong.	stamp position.
When using Combine,	You specified a reproduc-	When you specify a reproduction
parts of the image are not	tion ratio that does not	ratio using Manual Paper Select
copied.	match the sizes of your	mode, make sure the ratio matches
	originals and copy paper.	your originals and the copy paper.

		Note
		❒ Select the correct reproduction
		ratio before using Combine
		mode.
Order of copies is not cor-	You placed originals in in-	When placing a stack of originals in
rect.	correct order.	the document feeder, the last page
		should be on the bottom.
		If you place an original on the expo-
		sure glass, start with the first page to
		be copied.
When using Duplex, copy	You placed originals in the	Place originals in the correct orien-
is made Top/Bottom even	wrong direction.	tation. ⇒ p.12 “Original Orienta-
though Left/Right is se-		tion”
lected, or copy is made
Left/Right even though
Top/Bottom is selected.
Paper does not output dur-	If you stop printing while	Press the {Reset} key and cancel
ing printing with stapling.	using the staple function,	copy settings, including stapling.
	papers not stapled during
	printing may be left in the
	staple unit.

86