Lanier LD075, LD060 manual Changing the Number of Sets, B Press the Sample Copy key

Copying

Note

❒When placing originals on the exposure glass, start with the first page to be copied. When placing originals in the docu- ment feeder (ADF), set so that the last page is on the bottom.

2 ❒ When placing original on the exposure glass or in the docu- ment feeder (ADF) using batch mode, press the {#} key after all have been scanned.

Note

❒If you press the [Suspend] key after checking the results, re- turn to step A to adjust copy set- tings as necessary. You can change the settings for Staple, Punch, Duplex, Copy Orienta- tion, Stamp, Margin Adjust, Cover/Slip Sheet and Desig- nate. However, depending on the combination of functions, you may not be able to change some settings.

Sample Copy

Use this function to check copy set- tings before making a long copy run.

Note

❒This function can be used only when the Sort function has been turned on.

A Select Sort and any other required functions, and then place the orig- inals.

B Press the {Sample Copy} key.

ZGVS070E

One copy set is delivered as a sam- ple.

C If the sample is acceptable, press the [Print] key.

The number of copies made is the number specified, minus one for the proof copy.

Changing the Number of Sets

You can change the number of copy sets during copying.

Note

❒This function can only be used when the Sort function has been turned on.

A While "Copying" is displayed, press the {Clear/Stop} key.

B Press the [Change Quantity] key.

C Enter the number of copy sets with the number keys, and then press the {#} key.

Note

❒The number of sets you can en-

ter depends on w hen the {Clear/Stop} key is pressed.

D Press the [Continue] key.

Copying starts again.

40