6. Insert the TPM into the TPM connector on the system board.

Figure 82. Installing the TPM

7.If you have lifted up the riser card assembly 1, reinstall it into the chassis. See “Replacing the riser card assembly 1” on page 159.

What to do next:

To work with another piece of hardware, go to the appropriate section.

To complete the installation, go to “Completing the parts replacement” on page 174. Then, you can configure the TPM function in the Setup Utility program. See “Configuring the TPM function” on page 64.

Removing the TPM

Attention: Do not open your server or attempt any repair before reading and understanding “Safety information” on page iii and “Guidelines” on page 81.

This topic provides instructions on how to remove the TPM if the server has one installed.

Chapter 6. Installing, removing, or replacing hardware 127

Page 139
Image 139
Lenovo RD430 manual Removing the TPM, Installing the TPM