Lenovo RD430 manual Updating the server configuration

7.Install the server into a rack cabinet using the rail kit that comes with the server. See the Rack Installation Instructions that comes with the server.

8.Reconnect external cables and power cord(s) to the server. See “Rear view of the server” on page 26 to identify the connectors on the rear panel of the server.

Attention: To avoid component damage, connect the power cord(s) last.

Note: In most areas of the world, Lenovo requires the return of the defective CRU. Information about this will come with the CRU or will come a few days after the CRU arrives.

Updating the server configuration

When you turn on the server for the first time after you install, remove, or replace a device, you might need to update the server configuration.

Some optional devices have device drivers that you must install. For information about installing device drivers, use the documentation that comes with each optional device. To obtain the supported device drivers for your server from the Lenovo Support Web site, go to http://www.lenovo.com/drivers and follow the instructions on the Web page to find and download the device drivers you need.

Refer to the following information resources to update the server configuration:

•To update the BIOS configuration, see “Using the Setup Utility program” on page 59.

•To update the RAID configuration, see “Configuring RAID” on page 70.

•To use the ThinkServer EasyStartup program, see “Using the ThinkServer EasyStartup program” on page 67.

•To update your system firmware, see “Updating the firmware” on page 78.

Chapter 6. Installing, removing, or replacing hardware 177