2.If you are replacing a hot-swap redundant power supply, press the release tab 1 in the direction as shown and carefully pull the handle 2 at the same time to slide the failing hot-swap redundant power supply out of the chassis.

Figure 85. Removing a hot-swap redundant power supply

3.Touch the static-protective package that contains the new hot-swap redundant power supply to any unpainted surface on the outside of the server. Then, remove the new hot-swap redundant power supply from the package.

4.Note the orientation of the new hot-swap redundant power supply and then slide it into the chassis until it snaps into position.

Figure 86. Installing a hot-swap redundant power supply

132ThinkServer RD430 User Guide

Page 144
Image 144
Lenovo RD430 manual Removing a hot-swap redundant power supply