Figure 108. Removing the 2.5-inch hot-swap hard disk drive or dummy tray

3.Touch the static-protective package that contains the new hot-swap hard disk drive to any unpainted surface on the outside of the server. Then, take the new hot-swap hard disk drive out of the package.

Note: Do not touch the circuit board on the hard disk drive.

4.Slide the new hot-swap hard disk drive into the drive bay from the front until it snaps into position and then completely close the handle.

Figure 109. Installing the 3.5-inch hot-swap hard disk drive

Chapter 6. Installing, removing, or replacing hardware 151

Page 163
Image 163
Lenovo RD430 manual Removing the 2.5-inch hot-swap hard disk drive or dummy tray