11.Carefully close the microprocessor retainer. Then, carefully close the small handle to lock the retainer into position and secure the new microprocessor in the socket.

Figure 98. Securing the microprocessor in the socket

12.Reinstall the heat sink. See “Installing or replacing a heat sink” on page 133.

13.If you are instructed to return the old microprocessor, follow all packaging instructions and use any packaging materials that are supplied to you for shipping.

What to do next:

To work with another piece of hardware, go to the appropriate section.

To complete the replacement, go to “Completing the parts replacement” on page 174.

Installing or replacing the optical drive

Attention: Do not open your server or attempt any repair before reading and understanding “Safety information” on page iii and “Guidelines” on page 81.

This topic provides instructions on how to install or replace the optical drive.

This topic applies only to the following server models:

Server models with eight 3.5-inch hard disk drive bays

Server models with 2.5-inch hard disk drive bays

For server models with 12 3.5-inch hard disk drive bays, there is no internal optical drive and you can use an external optical drive if needed.

Chapter 6. Installing, removing, or replacing hardware 143

Page 155
Image 155
Lenovo RD430 manual Installing or replacing the optical drive, What to do next