connect the mini-SAS connector on the other end of the cable to the mini-SAS ports 0-3 on the backplane.

2.If your server has more than four hard disk drives installed, for hard disk drive 4 to hard disk drive 7, use another mini-SAS to mini-SAS signal cable and connect the mini-SAS connector on one end of the cable to the SAS connector 4-7 on the system board. Then, connect the mini-SAS connector on the other end of the cable to the mini-SAS ports 4-7 on the backplane.

Refer to the following topics for information about the connector locations and the power cable connections:

“Hot-swap hard disk drive backplane” on page 38

“System board components” on page 47

System board components

The following illustration shows the component locations on the system board.

Figure 37. System board components

 

 

Front panel connector

 

 

ThinkServer Management Module

 

1

 

16

 

 

 

 

 

 

 

 

Internal USB connector 1

 

 

Riser card assembly 1 slot

 

2

17

 

 

 

 

 

 

 

 

Internal USB connector 2

 

 

Riser card assembly 2 slot

 

3

18

 

 

 

 

 

 

 

 

Diagnostic module connector

 

 

Redundant power supply connector 1

 

4

19

 

 

 

 

 

 

 

 

Front VGA connector

 

 

Redundant power supply connector 2

 

5

20

 

 

 

 

 

 

 

 

SATA connector 0

 

 

Backplane power connector 1

 

6

21

 

 

 

 

 

 

Chapter 3. Product overview 47

Page 59
Image 59
Lenovo RD430 manual System board components