Step 4: Install memory, firmware, or option cards
CAUTION: If you are installing memory or option cards sometime after setting up the printer, turn the printer off and unplug the power cord before continuing.
Note: You need a small Phillips screwdriver to remove the system board access cover and to install some of the cards.
If you do not have any memory, firmware, or option cards to install, skip this step and go to Step 5: “Load paper” on page 31.
You can customize your printer memory capacity and connectivity by adding optional cards.
The instructions in this section help you install any of the following:
•Memory cards
–Printer memory
•Firmware cards
–Additional functionality
–Internet capabilities
–Flash memory
•Option cards
–Hard disk with adapter card
–MarkNet™ internal print servers (also called internal network adapters or INAs)
–Serial Interface Card
–Parallel
Install memory, firmware, or option cards
21
