Lexmark 752 setup guide Verifying the IP settings Configuring for Pull Printing, Ping

Press Menu until you see Set IP Netmask, and then press Select. Repeat step 6 to set the IP Netmask.

Press Menu until you see Set IP Gateway, and then press Select. Repeat step 6 to set the IP Gateway.

Verifying the IP settings

Note: On Windows computers, click Start Programs Command prompt (or Accessories Command prompt if using Windows 2000).

Configuring for Pull Printing

7

8

9

10

11 When you are finished, press Go to return the printer to the Ready state.

1 Print another network setup page. Look under the “TCP/IP” heading and make sure the IP address, netmask, and gateway are what you expected. See “Printing a network setup page” on page 53 if you need help.

2 Ping the printer and verify that it responds. For example, at a command prompt on a network computer, type “ping” followed by the new printer IP address (for example, 192.168.0.11):

ping 192.168.0.11

If the printer is active on the network, you receive a reply.

If your printer has an optional Lexmark ImageQuick™ firmware card installed, you can configure for Pull Printing once an IP address is assigned to the printer.

For detailed configuration instructions, refer to the CD that shipped with the Lexmark ImageQuick card.

Configure for TCP/IP

55