Message | What this message means | What you can do |
Prog System Code | The printer is programming new | Wait for the message to clear and the |
| system code. | printer to reset. |
|
| Warning: Do not turn the printer off while |
|
| this message is displayed. |
|
|
|
Program Flash | The printer is storing resources, such | Wait for the message to clear. |
| as fonts or macros, in flash memory. | Warning: Do not turn the printer off while |
|
| |
|
| this message is displayed. |
|
|
|
Programming Disk | The printer is storing resources, such | Wait for the message to clear. |
| as fonts or macros, on the hard disk. | Warning: Do not turn the printer off while |
|
| |
|
| this message is displayed. |
|
|
|
Programming Error | An error occurred while the printer was | Correct the problem specified on the |
P<x> | programming code into memory. | second line of the display: |
|
| • |
|
| program a |
|
| network file was used to program a |
|
| network printer. |
|
| • |
|
| program the printer, but the information |
|
| did not fit within the space allocated in |
|
| the Master Boot Record. |
|
| • |
|
| update the DLE code on a printer with a |
|
| firmware card installed, but the DLE was |
|
| not found on the firmware card. |
|
| • |
|
|
|
Queuing and Deleting | The printer is deleting one or more | Wait for the message to clear. |
Jobs | held jobs and sending one or more | See also: Printing and deleting held jobs |
| jobs to print. |
|
Queuing Jobs | The printer is sending one or more | Wait for the message to clear. |
| held jobs to print. | See also: Holding a job in the printer |
|
| |
|
|
|
Ready | The printer is ready to receive and | Send a job to print. |
| process print jobs. |
|
|
|
|
Ready Hex | The printer is in Hex Trace mode and | • Send a job to print. All data sent to the |
| is ready to receive and process print | printer is printed in hexadecimal and |
| jobs. | character representation. Control strings |
|
| are printed, not executed. |
|
| • Turn the printer off and then on to exit |
|
| Hex Trace mode and return to Ready |
|
| status. |
|
|
|
Reattach <device> | The specified device is either not fully | • Reestablish communication by removing |
| connected to the printer or is | the specified device and reattaching it to |
| experiencing a hardware failure. | the printer. |
|
| • Press Go to clear the message and |
|
| continue printing without using the |
|
| device. |
|
| • In the case of a hardware failure, turn |
|
| the printer off and back on. If the error |
|
| recurs, turn the printer off, remove the |
|
| specified device, and call for service. |
|
| See also: Calling for service |
|
|
|
82
