![](/images/new-backgrounds/1145128/145128191x1.webp)
Return to Section TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
STATIC SCR/DIODE RECTIFIER BRIDGE TEST (continued)
FIGURE F.13 – CONTROL BOARD PLUG J6 LOCATION
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
PLUG J6
TEST PROCEDURE
1.Turn off the engine.
2.Disconnect the welding cables from the welding output terminals.
3.Perform the Case Removal Procedure (including front shroud removal).
P e l 9 9 6
4.Using the 5/16” nut driver, remove the control board cover. See Figure F.13.
5.Locate and remove molex plug J6 from the control board. See Figure F.13.
Return to Section TOC
Return to Master TOC