Lincoln Electric SVM149-A service manual Output Connections, Torch

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

A-5 A-5

INSTALLATION

NOTE: When using nitrogen gas from a cylinder, the cylinder must have a pressure regulator.

•Maximum psi from a nitrogen gas cylinder to the PRO-CUT 25 regulator should never exceed 150 psi.

•Install a hose between the nitrogen gas cylinder regulator and the PRO-CUT 25 gas inlet

.

WARNING

CYLINDER could explode if dam- aged.

• Keep cylinder upright and chained to a fixed support.

•Keep cylinder away from areas where it could be damaged.

•Never lift machine with cylinder attached.

•Never allow the cutting torch to touch the cylinder.

•Keep cylinder away from live electrical parts.

•Maximum inlet pressure 150 psi.

__________________

OUTPUT CONNECTIONS

Torch

The PRO-CUT 25 is sent from the factory with a 15’ PCT 20 cutting torch installed. Additional cutting torch- es can be ordered from the K1615 series. Hand-held torches come with 15' or 25’ cables.

PRO-CUT 25