ACCESSORIES | ||
| ||
|
|
|
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
LOADING ALUMINUM WIRE
1.Remove gas cone and contact tip. Remove spool cover by unscrewing captive locking knob.
FIGURE C.5
2.Remove locking knob from spindle bolt by unscrew- ing it.
FIGURE C.6
3.Select wire alloy and diameter needed. Alloy 4043 and 0.035 wire size shown. Remove packaging and data sheet from wire spool.
FIGURE C.7
Size
Alloy
4.Extend approximately 12 inches of wire from spool. Straighten it out by
FIGURE C.8
5.Cut off bent end of wire, leaving straight section.
FIGURE C.9
6.Gently pull open the idle roll assembly to expose the drive roll groove.
