Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
ACCESSORIES | |||
|
| ||
|
| ||
7. Guide straightened wire through inlet wire guide | 10a. Alloy 4043: Roll up remaining wire back onto | ||
and toward drive roll groove. |
| spool and place spool onto gun spindle. Install | |
|
| locking knob and | |
FIGURE C.11 |
|
| FIGURE C.14 |
| 10b. Alloy 5356: Install Conical Spring, small end first, | |
| onto gun spindle (A). Roll up remaining wire back | |
8. While holding open the idle roll, slide end of wire | onto spool and place spool onto gun spindle. | |
Install locking knob and | ||
through drive roll’s groove and toward gun tube liner. | ||
Go to step 11. | ||
FIGURE C.12 | ||
FIGURE C.15 | ||
|
A
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
9.Slide the wire into the liner until it extends approxi- mately 1 inch beyond the end of the gas diffuser. Release idle roll tab without snapping it.
FIGURE C.13
11.Grasp the free end of the wire at the gas diffuser and slowly pull approximately 12 to 24 inches of wire through the spool gun. There should only be 1 to 2 lbs. of resistance. If force is greater than 2 lbs. wire is binding in the gun (also see Troubleshooting guide).
