![](/images/new-backgrounds/1319064/319064357x1.webp)
Appendix C: DDNS Setup (Advanced)
Accessing your NVR within a local network (LAN)
You can connect to your NVR on the local area network (LAN). It is recommended to confirm connectivity over a local network before setting up your NVR for Internet connectivity.
NOTE: To complete the steps below, your computer must be on the same network as your NVR.
Step 1 of 3: Connect your NVR to the Local Area Network
1Power off your NVR by turning the power switch to .
2Connect an Ethernet cable (included) to the LAN port on the rear panel of the NVR. Connect the other end of the Ethernet cable to an empty LAN port (usually numbered 1~4) on your router.
3Turn the power switch to I to power the NVR back on.
Ethernet Cable (included)
INTERNET
(not required for local viewing)
ROUTER | COMPUTER | |
(Not Included) | ||
(Not Included) | ||
|
Step 2 of 3: Obtain the NVR’s Local IP Address
1
NVR IP address
2Write down the IP Address.
161