Configuration
• Sender’s Address: Enter the sender’s email address.
NOTE: To enter ’@’ or other special characters using the | to bring |
up special characters. Click characters to input and click the arrows to view other characters.
Click to view other special characters
Click to open special character selector
•Receiver Email: Enter the email address that will receive alerts.
•Select Receivers: Use to enter additional email addresses that will receive alerts. Alerts may be sent to up to 3 addresses.
•Enable Attached Picture: Check to include an image attachment from the camera that triggered the alert.
•Interval: Select the interval the NVR will wait between sending out emails when events occur.
Select Default
Enter sender’s address
Enter additional receivers
Enter receiver’s address Enablepictureattachment Select Interval
5Click Apply to save your settings. Click Test to send a test email.
NOTE: Before the NVR will send out email alerts for motion detection, you must enable the Send Email action for each camera. See “Configuring Motion Detection Alarm Settings” on page 59.
Configuring DDNS Settings
Lorex DDNS is available as an optional connectivity option. Please see “Appendix C: DDNS Setup (Advanced)” on page 160 for details.
The primary connectivity option uses the Lorex Stratus service to connect to your system over the Internet without requiring port forwarding or DDNS registration. For details, see “Connecting to Your NVR Over the Internet on PC or Mac” on page 83.
To configure DDNS settings:
1
71
