User Manual version 2503

2.2. System Setup for the First-time Use

To set up the LIBRA system for the first-time use, you should have the following items ready. The items are either in the accessory box or available in any computer stores.

u110V or 220V power cord

uPS/2 keyboard or USB keyboard

uPS/2 mouse or USB mouse

2.2.1. Installation Procedures

The LIBRA system can be powered by an AC electrical outlet (115~230V/4A @47/63Hz). Be sure to use the right power cord (110V or 220V) for connection.

1.Insert the 3-pin female end of the power cord to the Kiosk cabinet from the rectangle opening located at the left rear side of the cabinet and have it connected to the power inlet of the power supply.

2.Connect the 3-pin male end of the power cord to an electrical outlet.

3.Open the Kiosk security door at the upper side. Connect a PS/2 keyboard and a PS/2 mouse to the PC’s PS/2 ports. Or connect a USB keyboard and mouse to the USB ports located at the right side of the Kiosk cabinet.

4.Power on the system by switching the power switch located at the I/O board.

LIBRA 120 III (PC620 Intel 815E)

2-15

PDF created with pdfFactory trial version www.pdffactory.com

Page 25
Image 25
March Products 120 III (PC620) user manual System Setup for the First-time Use, Installation Procedures