User Manual version 2503
After integrating the motherboard and touchscreen controller to the reverse side of the display module, all the cable connection needs to be done.
5.There are three cables, touchscreen flat cable, LCD cable and invertor cable coming out from the rear-side opening of the LCD holder. Connect the other end of the touschcreen flat cable to the 5-pin header connector, P5 on the touchscreen controller. Connect the DF11-30 end of the LCD cable to the LCD2 on the motherboard. Connect the 4-pin invertor cable to the motherboard’s INV1.
6.For Elo resistive touch, the touchscreen cable is a ribbon cable with 2*5 box headers at both side. Connect one end to P1 on the touchscreen controller with the other end firmly plugged to the motherboard COM3.
7.There is a 2-pin (black & red) wire to provide the power source for the touchscreen. Connect the 2-pin touchscreen power wire to P2 on the touch controller with the other end of plugged to the onboard CN1.
8.Connect one end of the 40-pin HDD ribbon cable to the onboard IDE1.
9.Connect one the 40-pin end of the CD-ROM ribbon cable to the motherboard IDE2 connector.
10.There is a 4-pin CD audio-in wire to be plugged to CD1 on the motherboard.
11.Connect the one end of the Y-shape USB cable the onboard USB3 and USB1 connectors. The other ends are for later connection to the exteriors of the Kiosk cabinet for external USB devices.
3-28 | LIBRA 120 III (PC620 Intel 815E) |
PDF created with pdfFactory trial version www.pdffactory.com
