Maytag AGR4412ADB/Q/S/W, CPL1100ADH/L/Q/T/W Conversion Instructions Models CP31200AD*, CG31200AD

Conversion Instructions (Models CP31200AD*, CG31200AD*)

￿￿￿ ￿￿￿￿￿￿￿￿￿￿

All ranges and cooktops are equipped with double coaxial (universal) orifices and with a convertible appliance pressure regulator. The unit model number plate states which gas it was adjusted for at the factory. To convert the unit to either Natural gas or LP gas will require adjustment of the orifice hoods, air shutters on the burners and adjustment of the appliance pressure regulator converter cap.

Inlet pressure to the appliance pressure regulator should be as follows for both operation and checking of appliance pressure regulator setting:

Minimum	5	11
Maximum	14	14

The unit appliance pressure regulator must be set to match the type gas supply used. If converting from natural gas to LP gas, the appliance pressure regulator must be converted to regulate LP gas. If converting from LP gas to natural gas, the appliance pressure regulator must be converted to regulate natural gas.

To convert the appliance pressure regulator from one gas to another, do either (1), (2) or (3) below: Your unit will be equipped with one of the three appliance pressure regulator types shown below.

1.Remove the cap, push down and turn counter-clockwise. Turn the cap over and reinstall (figure 12).

The gas type you are converting to must be visible on the top of the installed appliance pressure regulator cap.

2.Remove plastic dust cover from cap nut on top of appliance pressure regulator. Remove cap nut from appliance pressure regulator (plastic dust cover comes off with nut). “IMPORTANT” remove plastic dust cover from cap nut and reinstall on opposite side of cap nut.

Reinstall cap nut to appliance pressure regulator and

replace dust cover.be sure marking for the type of gas to which appliance pressure regulator has just been converted is visible in top of cap nut before replacing plastic dust cover. (See figure 13).

3.Remove cap and forcibly snap out plastic plunger from bottom of cap. Turn plunger over and forcibly snap back in original location (figure 14).

Plunger snap into position; the gas type

you are converting to must be visible on lower side of plunger.

C–2 16023522 ©2004 Maytag Services