Maytag CGR1110ADQ/W, CPL1100ADH/L/Q/T/W Surface Burner Conversion Conventional, To Reassemble

Conversion Instructions (Models AGR4400AD*, AGR4412AD*, MGR4451AD*, MGR4452AD*, PGR4420LD*, CGR1425AD*, CGR1415AD*, CGR1110AD*, CP31600AD*)

5.Place the corresponding orifice hood on the burner fitting according to figure 4. Turn the orifice hood clockwise by hand approximately one turn. Tighten the orifice hood clockwise with a ½￿ socket wrench approximately 2½ turns.

6.Replace the burner assembly in the main top and rotate one-eighth turn clockwise using the burner wrench until the burner locks in place with the igniter aligned with the reference mark on the main top.

7.Repeat steps 3 through 6 until all orifice hoods have been changed.

LP GAS SURFACE BURNER ORIFICE CONFIGURATION

6.5K BLUE	8K NO COLOR
STAMPED .0310	STAMPED .0335
	ART. #9215-250-2

8K NO COLOR	8.5K RED
STAMPED .0335	STAMPED .0350
	FRONT OF RANGE

NATURAL GAS SURFACE BURNER ORIFICE CONFIGURATION

7.2K BLUE	9.2K NO COLOR
STAMPED .0512	STAMPED .0571
	ART. #9215-250-2

To Reassemble:

Replace burner assembly in main top and rotate approximately one-eighth turn clockwise using burner wrench until burner locks into position with ignitor aligned with reference mark on main top.

ORIFICE HOOD

FIGURE 5

Surface Burner Conversion (Conventional

Burner)

1.Remove main top.

2.Remove all (4) surface burners.

3.Remove all (4) orifice hoods (figure 6) from the valve by using a 1/2 wrench or socket and turning the hood counter-clockwise.

ORIFICE - Nat.: Stamped .0571

LP: Stamped .0335

FIGURE 6

NOTE: Save all parts removed in conversion.

4.Replace with the hoods stamped .0335 for LP (.0571 for natural) by using a 1/2 inch wrench or socket and turning the hood clockwise approximately (6) complete turns.

5.Replace surface burners.

9.2K NO COLOR		12K RED
STAMPED .0571	FRONT OF RANGE	STAMPED .0669

FIGURE 4

C–14 16023522 ©2004 Maytag Services