Disassembly Procedures
!WARNING
To avoid risk of electrical shock, personal injury, or death: disconnect electrical and gas supply before servicing.
Oven Door Hinge Receiver
1.Turn off power to unit.
2.Remove oven door, see "Oven Door Removal" procedure.
3.Remove maintop assembly, see "Maintop Assembly" procedure, steps 1 through 5.
4.Remove side panel, see "Side Panel Removal" procedures.
5.Remove the top and bottom screws securing hinge assembly to the front frame.
6.Remove hinge from oven chassis.
7.Reverse procedure to reinstall oven door hinge.
Side Panel Removal
1.Turn off power to unit.
2.Remove oven door, see "Oven Door Removal" procedure.
3.Remove maintop assembly, see "Maintop Assembly" procedure, steps 1 through 5.
4.Remove screws securing lower rear galvanized cover from unit.
5.Remove screws securing top and back of side panel.
6.Pull rear of side panel away from range then slide side panel forward to release from side panel spacers.
7.Reverse procedure to reinstall side panel.
Backguard
NOTE: Requires removal of oven from installation position.
1.Remove maintop assembly, see "Maintop Assembly" procedure, steps 1 through 6.
2.Remove screws securing upper back panel form unit.
3.Remove screws securing bottom outside edges of the backguard to unit chassis.
4.Reverse procedure to reinstall backguard.
Storage Drawer Removal
1.Pull drawer straight out to first stop. Lift the front and pull out to second stop.
2.Let front of door rest on floor. Place hands toward back of drawer and lift it out.
3.To replace:
a.Place the set of rollers on the drawer behind the set of rollers on the oven. (As shown above.)
b.Align the guides and push the drawer back into position.
Storage Drawer Track Removal
1.Remove the storage drawer by pulling it out to the fully open or stop position, lifting the drawer at the rear to disengage the drawer track rollers from the drawer runners, and sliding the drawer out of the range.
2.The tracks are mounted to a rear support and the frame of the range. Remove the two track mounting screws and remove the track. If the track support is being replaced, remove the mounting screw securing it to the side frame and remove the support.
Warming Drawer Removal
1.Pull warming drawer out as far as it will go.
2.Located on each side of the track is a plastic lever inside the track location. Push the left side down and the right side up to release slide from track and pull forward.
3.When installing warming drawer, align slide with track and push warming drawer into place.
Warming Drawer Element
1.Remove warming drawer, See "Warming Drawer Removal" procedure, steps 1 and 2.
2.Remove screws securing element to bottom and back of chassis.
3.Pull element forward until element end are through the back of the unit.
4.Disconnect wire terminal from element.
5.Reverse procedure to reinstall element.
Convenience Outlet/Circuit Breaker (Canadian Models)
1.Remove control panel, see "Control Panel" procedure for removal.
2.Label and disconnect wire terminals from convenience outlet and/or circuit breaker.
3.Remove screws securing outlet and/or circuit breaker to backguard and push outward to release.
4 . Reverse procedure to reinstall convenience outlet and/or circuit breaker.
22 | 16023522 | ©2004 Maytag Services |
