IMPORTANT SAFETY INSTRUCTIONS
Technical safety
Installation, repair and maintenance work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and may void the warranty.
Before installing the steam oven, check for externally visible damage. Do not operate a damaged appliance. A damaged appliance is dangerous to your safety.
Be certain your appliance is properly installed and grounded by a qualified technician. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. It is imperative that this basic safety requirement be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician.
Before installation make sure that the voltage and frequency listed on the data plate correspond to the household electrical supply.
This data must match in order to avoid damage to the appliance. If in doubt, consult a qualified electrician.
Hardwiring the appliance should be performed by a certified electrician in compliance with all local and national codes, and requirements.
Power bars and extension cords do not guarantee the required safety of this appliance (risk of fire). Do not use them to connect the steam oven to the electrical power supply.
To ensure safe operation, use the steam oven only after it has been properly installed.
This appliance is not to be used in mobile locations such as ships.
Never open the outer casing of the appliance. Tampering with electrical connections or components and mechanical parts is dangerous and could cause machine damage.
Defective components should be replaced by Miele original spare parts only. Only with these parts can the manufacturer guarantee the safety of the appliance.
Do not repair or replace any part of the appliance unless specifically recommended in the manual. All other servicing should be reffered to a qualified technician
Do not operate any appliance with a damaged cord or plug, or if the appliance has been damaged in any manner. Contact Miele’s Technical Ser- vice Department.
If the power cord is damaged, it must be replaced with a special cord (Type H 05
Before installation or service, disconnect the appliance from the power supply by either removing the fuse, "tripping" the circuit breaker or unplugging the unit. Pull the plug not the cord.
7
