Miller Electric Welder operating instructions Setting Run-in Sequence Display

11-8. Setting Postflow Sequence Display

>Poflw 0.0 Sec

1

	Poflw
	> 0.0 Sec
Parameter	Set Desired Time
Select
	Increase/
	Decrease

> Poflw

1.2 Sec

Parameter

Select

1 Postflow Parameters Display

Postflow can be adjusted from 0-9.9 seconds. If value set is zero (0), there is no Postflow sequence.

11-9. Setting Run-in Sequence Display

>Runin

ON

100 IPM

1

Runin

>ON

100 IPM

Parameter Set ON or OFF Select

Increase/

Decrease

Runin

ON

> 120 IPM

Parameter Set Desired Speed

Select

Increase/

Decrease

>Runin

ON

120 IPM

Parameter

Select

.Run-in parameters are not

global across multiple programs; instead, run-in wire speed is local at the run-in program level.

1 Run-in Parameters Display

Runin can be turned On or Off. Runin is a function of wire feed speed only. This is the speed at which wire feeds until an arc is established.

IPM 25-780 (0.6-19.8 mpm).

The voltage setting will be the same as Start sequence if time is set in that sequence; otherwise, this sequence will use the welding power source voltage setting.

OM-196 188 Page 99