Miller Electric Welder operating instructions Setting Retract On/Off, Setting Sharp Start On/Off

15-5. Setting Retract On/Off

Access

Control

Display

Press Mode

Select

Adaptive

AutoConfig

>Retract ShrpStrt

1

>Retract On

Increase/

Decrease

1 Retract Display

Settings allow user to turn the re- tract feature On or Off. The retract feature allows the user to set a time and wire feed speed to pull wire away from work when the weld is done.

Use Increase or Decrease button to change setting. If the retract feature is turned On, a weld sequence step is added in the process screens.

>Process Sequence SharpArc Card

>Prg 1 Pulse 035” Steel Argon – Oxy

Power	> Retract
Switch
	Off

Mode

OrSelect

Press Mode Select button to go to next parameter or cycle power off and back on at power switch to sav- e setting and exit Control menu.

Go To

Section 15-6

15-6. Setting Sharp Start On/Off

Access

Control

Display

Press Mode

Select

AutoConfig Retract

>ShrpStrt Exit

1

>ShrpStrt On

Increase/

Decrease

1 Sharp Start Display

Settings allow user to turn the sharp start feature On or Off.

.Sharp start should normally be left On. The ability to turn sharp start Off is provided in case the user experiences problems with weld ends using flux cored wires.

Use Increase or Decrease button to change setting.

>Process

Sequence SharpArc

Card

>Prg 1 Pulse 035” Steel Argon – Oxy

Power	> ShrpStrt
Switch
	Off

Mode

OrSelect

Press Mode Select button to go to next parameter or cycle power off and back on at power switch to sav- e setting and exit Control menu.

Go To

Section 15-4

OM-196 188 Page 122