Miller Electric Welder operating instructions Using Setup Displays, T u p

14-2. Using Setup Displays

2

Mode Parameter

Select Select

1

S e t u p

Front Panel Display

Access

Mig Type

Aux Out

Voltage

	1	Front Panel Setup Display
3	Front panel display during setup.
	2	Pulse Panel Mode And
		Parameter Select Buttons
	3	Power Switch On Rear Panel
	Press and hold down both buttons
	while turning On unit.
	4	Setup Pendant Display

Follow this procedure any time access is required. Once in the set- up displays, use the Mode Select button to select a particular display.

To save any or all of the changes made while in the setup displays, and/or to exit the setup displays, turn power to the unit Off and back On.

4

>Volt Min 10.0 Volt

Setup Pendant Display

OM-196 188 Page 108