Miller Electric Welder Setting Crater Sequence Display, Setting Retract Sequence Display

11-6. Setting Crater Sequence Display

> Cratr	1
0.02 Sec
24.0 Volt
90 IPM

Parameter

Select

Cratr		Cratr		Cratr
> 0.12 Sec		0.12 Sec		0.12 Sec
24.0 Volt		> 18.0 Volt		18.0 Volt
90 IPM		90 IPM		> 200 IPM
Set Desired Time	Parameter	Set Desired	Parameter	Set Desired Wire
	Select	Voltage	Select	Feed Speed
Increase/		Increase/		Increase/
Decrease		Decrease		Decrease
			> Cratr
			0.12 Sec
			18.0 Volt
			200 IPM
				Parameter
				Select
			Increase
			Proceed to next Section.

1 Crater Parameters Display

Parameter ranges are as follows:

Seconds, 0-2.50 Sec. If value set is zero (0), there is no Crater sequence.

Volts, 10.0-38.0 Volts.

Wire Feed Speed, 50 to 780 inches per minute, IPM.

Go to Section 11-7.

11-7. Setting Retract Sequence Display

>Rtrct

150 IPM

0.00 Sec

1
	Rtrct		Rtrct
	> 150 IPM		120 IPM
	0.00 Sec		> 0.00 Sec
Parameter	Set Desired Speed	Parameter	Set Desired Time
		Select
Select
	Increase/		Increase/
	Decrease		Decrease

> Rtrct

130 IPM

0.12 Sec

Parameter

Select

Increase

Proceed to next Section.

1Retract Parameter Display Parameter range is as follows:

Seconds, 0-1.00 seconds. If value set is zero (0), there is no Burnback sequence.

IPM 50-780 (1.3-19.8 mpm). Speed is program dependent.

Go to Section 11-8.

OM-196 188 Page 98