Miller Electric Welder operating instructions Lower Front Panel Controls, Meter Functions

System Reset	By selecting system reset in the memory reset mode, the unit defaults to original factory settings for
	all programs and all set up excluding System, Arc Time, and Model Type.
Voltage (Control Feedback)	Allows voltage to be monitored at the output terminals by two methods. This can be selected through
	the internal connections of the unit, or through the unit’s external voltage sense lead.
	When using the V. Sense setting, arc voltage feedback is through the voltage sense leads connected
	to the feeder. Use this setting when there is more than 50 ft (15 m) of weld cable used.
Arc Start/Volt Sense Shutdown	When this feature is on, the system immediately shuts down if no arc voltage is sensed. An error
	message is displayed. When this feature is off, wire feeds even when there is no arc voltage sensed.
Wire Feed Mode	Allows the selection of inches per minute or meters per minute for wire feed speed. This mode is also
	used to select motor type; standard speed, low speed, or high speed.
4-2. Lower Front Panel Controls
1	2	3

CE

1 Power Switch 2 Voltmeter (see Section 4-3) 3 Ammeter (see Section 4-3)

.The fan motor is thermostatically controlled and only runs when cooling is needed.

								Ref. 186 067
4-3. Meter Functions
Note	The meters display the actual weld output values for approximately three seconds after the arc
	is broken.
Mode			Meter Reading At Idle			Meter Reading While Welding
			V		A	V		A
MIG			24.5			24.5		250
			Preset Volts		Blank	Actual Volts	Actual Amps
			V		A	V		A
Pulsed			PPP		PPP	24.5		250
MIG
		Pulse Display		Pulse Display		Actual Volts	Actual Amps

OM-196 188 Page 21