Miller Electric Welder Setup Flow Chart, Features Settings Default Section

SECTION 14 – SETUP

14-1. Setup Flow Chart

1		Access			> Volt Min
Example Setup		Mig Type			10.0 Volt
Pendant Display		Aux Out
		Voltage
Display	Features		Settings	Default		Section
Selection
>Access	Code		Off/On	Off		14-3
Press Mode Select To
Go To Next Setup Dis-
	play
>Mig Type	Voltage		DVC On/Off	Off		14-4
	Correction
>Aux Output	Auxiliary		Output On	Never		14-5
	Output		w/Feeder
			w/Arc
			w/Weld Cycle
			Never
>Voltage	Control		Internal	Internal		14-6
	Feedback		Volt Sense
>Arc Start	Arc Start		Standard	Standard		14-7
	Type		Hot Start
			Soft Start
>Arc Time	Run Hours		0–9999.99			14-8
			Hours
			0–999,999
			Cycles
	No Reset			No Reset
	Reset
>Wire Feed	Display		IPM/MPM	IPM			14-9
	Motor Type		Standard	Standard
				Low Speed
				High Speed
>Wiretype	Wire Type		Hardwire/	Hardwire		14-10
			Softwire
>Display			Actual	Command		14-11
			Amps
			Command

1Display Selections

2Features

23 Settings

3To set up features that customize operation, use the setup displays. Features that can be customized are as follows:

Display	Features	Settings	Default	Section
Selection
>Memory	No Reset		No Reset	14-12
	Program
	Reset
	System
	Reset
	Total
	Reset
>Shutdown	Arc Start/	Off/On	On	14-13
	Volt Sense
>Name	Card	Off/On	On	14-14
	Programs
>Program	Remote	Off/On	Off
				14-15
	Select
>Jog IPM	Robot Jog	Remote/Local	Local
	Local Jog
	IPM	50 - 780	200	14-17
>Flow	Detect Flow	Off/On	Off
				14-18
>Monitor	Arc Volts	Off/On	Off
				14-19
	Range	0.1 - 9.9	2.0 Volts
	Sec	0.1 - 25	1.0 Sec.
>Stick	Stick Check	Off/On	Off	14-20
>Ramps	Program	Number
			1	14-21
	Start	Off/On	Off
	Crater	Off/On	Off
>Software	Version
				14-22
Number
>Exit	Exit Setup	Press
	Menu Now			14-23

OM-196 188 Page 107