Minolta 0990-7701-02 user manual Network Board Option Setting-Up

14

Installation CHAPTER 1

3. Setting-Up

Network Board (Option) Setting-Up

PRECAUTION

-The network board is equipped with the following two types of interface connectors for connection to the network server. Select the correct interface to suit the network to be used.

10BASE-T 10BASE-2

3. Setting-Up

-ExpansionThe type of cable usedMemoryfor connecting Settingthe printer to -the network server varies depending on the connection method of the network to be used. (The accessories that come with the network board do not contain a cable.)

Study the operator's manual of your network and purchase the correct cable applicable to the connection between the

CAUTION

printer and network server.

CAUTION

-Do not make connections both to 10BASE-T and 10BASE-2 at the same time, because it will deactivate the automatic detection function of the connector connected, disabling communications.

-Before opening the optional packages or handling the options, briefly touch the metal part of the printer to remove any electrostatic charge from your body.

-When options are taken out of their conductive bags or off their mats, hold them by their edges to avoid touching the terminals or the patterned surfaces.

-When Controller board is taken out of the printer, hold it by the edges to avoid touching the terminals or the patterned surfaces.

-After removing the options or Controller board, be sure to place it on an anti-static mat or a piece of aluminum foil.

1

-Turn the printer OFF.

Power Switch

3

NOTE

-When the Network Board is taken out of its conductive bag or off its mat, hold the Network Board by the edges to avoid touching the terminals or the patterned surfaces.

2

-Remove the two screws that secure the network board panel on the back of the printer.

-Remove the network board panel.

4

-Take the Network Board out of its carton.