Mitsubishi Electronics DV1248ST user manual Test the Scanner

Figure 1-6

Plug the SCSI terminator into the 25 pin connector of the scanner’s rear panel.

Plug the power cord into the power receptacle of the scanner’s rear panel and the other end into a power outlet. Tighten the screws on all connectors.

Test the Scanner

Reconnection the power cord to your computer. Turn the power of your scanner on and wait until the scanner completes its self-test. The LED indicators will first blink for a few seconds and then remain on. Now start your computer, you are ready to install the software for your new scanner once the operating system has loaded.