4 - 9
4. STARTUP
2) Operation method
Operation Screen control
Forward rotation start Click the "Forward" button.
Reverse rotation start Click the "Reverse" button.
Pause Click the "Pause" button.
(c) Program operation
Positioning operation can be performed in two or m ore operation patterns combined, without using the
servo system controller. Use this operatio n with the forced stop reset. This operation may be used
independently of whether the servo is on or off and whether the servo system controller is co nnected or
not.
Exercise control on the programmed oper ation screen of the MR Configurator. For full infor mation, refer
to the MR Configurator Installation Guide.
Operation Screen control
Start Click the "Start" button.
Stop Click the "Reset" button.
(d) Output signal (DO) forced output
Output signals can be switched on/off forc ibly independently of the servo status. Use this function for
output signal wiring check, etc.
Exercise control on the DO forced output screen of the MR Configurator.
(2) Operation procedure
(a) Jog operation, positioning operation, pro gram operation, DO forced output.
1) Switch power off.
2) Set SW2-1 to "UP".
SW2
DOWN
UP
12
Set SW2-1 to "UP"
When SW1 and SW2-1 is set to the axis number and operation is performed by the servo system
controller, the test operation mode screen is displ ayed on the personal computer, but no function is
performed.
3) Switch servo amplifier power on.
When initialization is over, the disp lay shows the following screen.
Decimal point flickers.
4) Perform operation with the personal comput er.