5 - 1
5. PARAMETERS 5. PARAMETERS
CAUTION Never adjust or change the parameter values extr emely as it will make operation
instable.
POINT
When the servo amplifier is connected with th e servo system controller, the
parameters are set to the values of the servo system controller. Switching
power off, then on makes the values set on the MR Conf igurator (servo
configuration software) invalid and the ser vo system controller values valid.
Setting may not be made to some parameters an d ranges depending on the
model or version of the servo system control ler. For details, refer to the servo
system controller user's manual.
In this servo amplifier, the parameters are c lassified into the following groups on a func tion basis.
Parameter group Main description
Basic setting parameters
(No.PA )
Make basic setting with these parameters. Generally, the operation is possible only with these
parameter settings.
Gain/filter parameters
(No.PB )
Use these parameters when making gain adjustment manually.
Extension setting parameters
(No.PC )
When changing settings such as analog monitor output signal or encoder electromagnetic brake
sequence output, use these parameters.
I/O setting parameters
(No.PD )
Use these parameters when changing the I/O signals of the servo amplifier.
Mainly setting the basic setting parameters (No.PA ) allows the setting of the basic parameters at the time
of introduction.
5.1 Basic setting parameters (No.PA )
POINT
Parameter whose symbol is preceded by * is made valid with the foll owing
conditions.
* : Set the parameter value, switch power off once after setting, and then
switch it on again, or perform the controller reset.
**: Set the parameter value, switch power off once, and then switch it on
again.
Never change parameters for manufacturer setting.