all DVRs were not created equal
Programming by search
If the TV or audio device is not listed, or the codes listed do not work, try programming by search. Programming by search allows the remote to cycle through codes to find one that works with the TV or audio device.
Once programmed with two device codes, the remote controls volume and mute for the second device. Follow these steps to program the remote to control audio device power and volume.
Some older devices may not be supported. If the device fails to respond to any code, use its original remote to control it.
1.Turn on the TV or audio device you want the remote to control.
2.On the Moxi remote, press and hold the Moxi and OK buttons simul- taneously until the LED at the top of the remote blinks twice.
3.Using the number buttons on the remote, press 9 9 1 0 for the TV, or 9 9 1 1 for the audio device. The LED light blinks twice.
To reset the remote to the original factory setting, enter code
99 9 9, and then press OK.
Using and programming the remote
4. Press the Mute button. |
| |
• | If this mutes the device, go to step 5. | 4 |
• | If this does not mute the device, press the up arrow to | |
| advance to the next code, and then press Mute again. | |
| Repeat until the device responds. | |
5.Press OK to set the current code and finish.
© 2006 by Digeo, Inc. All rights reserved. | Media Center User Guide | 45 |
