RAS96 RASCard User Guide
To Configure the E1 Daughter Card
1.Turn on power to the segment containing the E1 Card to be configured.
2.Log in to the controller as supervisor, supervisor and type the command E1status 1b (5b, 9b, or 13b) for
3.If the line settings do not match the line settings of your E1 line, type the command E1setup 1b (5b, 9b, or 13b) at the A:# prompt.
4.The E1 setup will take you through a series of menus where you will enter the information that was gathered in the Installation Overview.
Factory Defaults: |
|
Framing: | CRC4 |
Line Coding: | HDB3 |
Signaling Options: | R2 digital |
5.When you save the changes at the end, the E1 parameters are then sent to the E1 card for configuration.
48 | CommPlete Communications Server |
