Nikon LS-2000 manual When the scanner is between other devices

3. Setup

When the scanner is between other devices

1. Set the terminator switch on the rear of the scanner to OFF

TERMINATOR

OFF ON

2.Connect the SCSI cable from one of the devices in the chain to either of the connectors on the rear of the scanner, then connect a cable to the remaining connector and attach the other end to a connector on the next device in the chain

100–240V~

0.3–0.2A 50/60 Hz

1 0 0 0 9 8	MADE IN JAPAN	SCSI NB
		4	5
	2		6
		1
	S C S I	0

Other SCSI device

TERMINATOR

OFF ON

S C S I

Terminator

3. Confirm that the last device in the chain is terminated

Note: If the last device in the chain has an unused SCSI connector, a separate terminator should be attached to it, even if the device is connected to the SCSI chain using a through terminator.

12 Nikon LS-2000 35 mm Film Scanner User’s Guide