Get to Know Your Scanner
Your Scanner
Rear View
|
|
| |
Front View | |||
|
Status LED
This LED blinks slowly (roughly twice every three seconds) when the scanner is in operation. Do not turn the scanner off, remove or insert adapt- ers, or eject or insert film until the LED has stopped blinking and is glowing steadily. If the LED flashes rapidly (about five times a second), a communications error has occurred or there is a problem with the scanner. Turn the scanner off, wait for at least five seconds, and then turn the scanner on again.
The first time you run Nikon Scan, the status LED will emit five series of rapid blinks (each of about three seconds duration) when you first insert a holder with the scanner on or if you start Nikon Scan for the first time with the scan- ner on and a holder in place. This does not indicate an error. Do not eject the holder.
Power switch
Press this switch to turn the scanner on and off.
Eject button
Use this button to eject holders from the scanner.
Holder Slot
This is where you put holders for different types of film. Don’t put anything in this slot except an approved Nikon holder.
Sliding cover
Slide the cover down before inserting a holder. To protect your scanner from dust and other foreign objects, be sure ALWAYS to close the cover when no holder is in place.
AC connector
Connect the female end of the power cable here.
IEEE 1394/Firewire interface connector Connect the IEEE 1394/Firewire interface cable here.
3
