Nikon LS8000 Connecting the Scanner, Connect the Power Cable, Connecting the Interface Cable

Connecting the Scanner

The first time the scanner is connected to a Windows computer, the Device Manager will install the device drivers needed to “register” the scanner with the system (more information on device registration is available on page 27 of this manual).

Connect the Power Cable

Before connecting the power cables, be sure the scanner is off. Attach the female end of the power cable to the AC connector on the rear of the scanner and insert the male end into a general-purpose (AC 100–240 V, 50/60 Hz) household outlet.

Power off Power on

Connecting the Interface Cable

After confirming that the scanner is off, connect one end of the supplied 6-pin–6-pin IEEE 1394 cable to the scanner, the other to the computer.

Connect the cable as shown. Attempting to insert the connector in another orientation could not only damage the connector, but also damage the scanner or computer or interfere with their correct functioning.

Scanner Computer

Align the curved portion of the connector (circled) with the matching portion of the connector on the scanner or computer.

IEEE 1394 connector

Important

If you are using a computer with a 4-pin DV connector (such as SONY VAIO laptop computers), you will need to purchase a 6-pin–4-pin cable or 6-pin–4-pin adapter.

25