DECT system configuration

Subscribing the handset to a DECT system

You must subscribe the handset to at least one DECT system before you can use the handset to make a call. The handset can operate with a maximum of four DECT systems, for which the handset stores the name of the system in a subscription record. Whenever the handset enters the range of a subscribed DECT system, the name of the system appears on the handset display.

Attention: If your supplier preinstalls the handset, you need not subscribe your handset to a system. When the handset is not yet subscribed to a system, the message “Register” appears.

Use the PABX-PIN code to register the handset with a DECT system.

Before you subscribe to a DECT system, obtain the following information from your system administrator:

PARK code: A system ID that enables your telephone to differentiate between DECT systems when more than one DECT system is present.

DECT system name: The name of the system to which you subscribe. After you enter the system name, it appears on the idle display.

Phone number: The local phone number assigned to your DECT handset.

Attention: Once you have obtained your PIN code, you have 15 minutes to subscribe the handset. After 15 minutes have elapsed, the PIN code is deactivated you must activate a new one.

To subscribe your handset to a DECT system, perform the following steps:

1.Open the Connectivity menu as shown in “Accessing the Connectivity menu” (page 46).

47

Page 47
Image 47
Nortel Networks 4075 manual Subscribing the handset to a Dect system